I’ve been trying to get my head round this - shouldn’t the force be taken by the stop bolts on the shifter box rather than the gear set / box housing?
Surely the gear will be properly engaged before the stick is pushed to it’s physical limit?
SurreyXedos
MOCGB Paid Member
Last Activity: 14-07-2019, 07:51 AM
Joined: 04-01-2012
Location: Frimley, Surrey
-
Was just about to post the same.
A good innings had.
Tomorrow will be a fitting tribute day for all things Mustang American.
EDIT:
https://en.wikipedia.org/wiki/Lee_Iacocca...Last edited by SurreyXedos; 03-07-2019, 08:48 AM.Leave a comment:
-
Youtube is probably your friend here - but basically you undo the rods at the selector box, move the selector levers until you can get a 1/4” drill or similar through the alignment holes in the selector box, and then wind the rods in or out until they just fit back in loosely without pulling on the...Last edited by SurreyXedos; 24-06-2019, 11:58 AM.Leave a comment:
-
You were polishing your car really weren't you
Leave a comment:
-
Well with a rough calculation of 18mpg that equates to 1/4 litre per mile - sounds like a trickle to me
...
Leave a comment:
No activity results to display
Leave a comment: